Wolo 150-24 Sea Alert User Manual download pdf

Your purchase of a Wolo SEA ALERT™ Air Horn will complement your boat, while offering an extra level of

protection. Wolo’s products are manufactured with the ﬁnest materials. Before being packaged, each horn

is tested to ensure it meets all of our manufacturing speciﬁcations. If you need help installing your new Wolo

horn, our technicians are available to answer your questions, Monday thru Friday, 9 AM to 4 PM EST at

1-888-550-HORN (4676).

Before installation of the horn is attempted, it is important to read these instructions completely. The lives of

people can be dependent on a proper installation of the horn. The person doing the installation must have

knowledge of the proper method for mounting and securing the horn to the exterior of the boat, as well as

knowledge of the boat’s electrical system. Again, read the instructions completely and note any messages

marked “IMPORTANT” or “WARNING’’. A safe installation will prevent injury or damage to the boat.

WARNING: Installation of the SEA ALERT requires drilling. The installer must carefully inspect both sides of

the selected mounting locations to ensure that there are no wires, fuel lines and or any other components that

could be damaged by drilling.

WARNING: If any wires are routed through drilled holes, always de-burr ensuring that there are no sharp

edges. Install a rubber grommet into all metal holes that wires are being routed through.

MOUNTING TRUMPET: Fig. 1 & 2

IMPORTANT: The horns should be mounted facing

forward whenever possible. The NMMA Certiﬁcation

Program requires this for boats 39’ or longer.

1. Locate the desired mounting location of the trumpets.

For best results, the front of the horn should be

unobstructed so that the sound can carry straight ahead.

IMPORTANT: FOR BEST PERFORMANCE AND

SOUND, ALWAYS MOUNT THE COMPRESSOR

CLOSE TO TRUMPET, KEEPING THE HOSE LENGTH

AS SHORT AS POSSIBLE. THE COMPRESSOR MUST

BE MOUNTED IN A DRY INTERIOR LOCATION).

2. Use the horn’s gasket as a template, mark hole

locations and drill to size.

3. Thread the chrome air inlet tube into the base of

the horn.

4. Mount and secure the horn as shown in Fig. 1.

IMPORTANT: Be sure to use the provided rubber

gasket to protect against water leaks. Tighten the

base plate front screw and rear nut that threads onto

the air inlet tube evenly to ensure a watertight seal.

5. Position the front trumpet support bracket around

the narrow part of the trumpet. IMPORTANT:

Provided in the kit is a soft rubber strip that is placed

into the ring of the support bracket to provide a tight ﬁt

and prevent vibration. Push the bracket forward until

it is tight. Use the bracket as a template, mark hole

locations and drill to size. See Fig 2.

INSTALLATION INSTRUCTIONS

Model 150-24 SEA ALERT Xtreme

™

24-Volt

air inlet

tube

1 2 3 4

Summary of Contents

Page 1 - Model 150-24 SEA ALERT Xtreme

Your purchase of a Wolo SEA ALERT™ Air Horn will complement your boat, while offering an extra level of protection. Wolo’s products are manufactured w

Page 2

6. Secure the front trumpet support bracket using the hardware provided. Tighten screws evenly to ensure a watertight seal. IMPORTANT: Be sure to use

Page 3

IMPORTANT: Connect relay terminal 85 to the same horn switch wire that is connected to other relay. WIRING:USING BOATS FACTORY HORN SYSTEM (TWO WIRE S

Page 4 - WARRANTY

ANY EXPRESSED WARRANTY NOT PROVIDED HEREIN IS EXCLUDED AND DISCLAIMED. THE IMPLIED WARRANTIES OF MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR PURPO

Wolo 150-24 Sea Alert User Manual

Browse online or download User Manual for Equipment Wolo 150-24 Sea Alert. Wolo 150-24 Sea Alert User Manual

Summary of Contents

More documents for Equipment Wolo 150-24 Sea Alert

Comments to this Manuals

Wolo 150-24 Sea Alert User Manual

Browse online or download User Manual for Equipment Wolo 150-24 Sea Alert. Wolo 150-24 Sea Alert User Manual

Summary of Contents

More documents for Equipment Wolo 150-24 Sea Alert

Comments to this Manuals

Related products and manuals for Equipment Wolo 150-24 Sea Alert