Wolo 160 Ocean Alert User Manual download pdf

Your purchase of a Wolo OCEAN ALERT™ Air Horn will complement your boat while offering an extra

level of protection. Wolo’s products are manufactured with the ﬁnest materials. Each horn is tested to ensure

it meets all of our manufacturing speciﬁcations, before being packaged. If you need help installing your new

Wolo horn, our technicians are available to answer your questions, Monday thru Friday, 9 AM to 4 PM EST

at 1-888-550-HORN (4676).

Before installation of the horn is attempted, it is important to read these instructions completely. The lives of

people can be dependent on a proper installation of the horn. The person doing the installation must have

knowledge of the proper method for mounting and securing the horn to the exterior of the boat as well as

knowledge of the boat’s electrical system. Again, read the instructions completely and note any messages

marked “IMPORTANT” or “WARNING’’. A safe installation will prevent injury or damage to the boat.

WARNING: Installation of the OCEAN ALERT requires drilling. The installer must carefully inspect both sides

of the selected mounting locations to ensure that there are no wires, fuel line and or any other components that

could be damaged by drilling.

WARNING: If any wires are routed through drilled holes; always de-burr ensuring that there are no sharp

edges. Install a rubber grommet into all metal holes that wires are being routed through.

MOUNTING TRUMPET: Fig. 1

IMPORTANT: The horn should be mounted

facing forward whenever possible. The NMMA

Certiﬁcation Program requires this for boats 39’

or longer.

1. Locate the desired mounting location of the

trumpet. For best results, the front of the horn

should be unobstructed so that the sound can

carry straight ahead.

IMPORTANT: FOR BEST PERFORMANCE

AND SOUND, ALWAYS MOUNT THE

COMPRESSOR CLOSE TO TRUMPET,

KEEPING THE HOSE LENGTH AS SHORT

AS POSSIBLE. THE COMPRESSOR

MUST BE MOUNTED IN A DRY INTERIOR

LOCATION).

2. Use the horn’s gasket as a template, mark

hole locations and drill to size.

3. Thread the two chrome air inlet tubes into the base of the horn.

4. Mount and secure the horn as shown in Fig. 1.

IMPORTANT: Be sure to use the rubber gasket provided to protect against water leaks. Tighten the base plate

nuts that thread onto air inlet tubes evenly to ensure a watertight seal.

INSTALLATION INSTRUCTIONS

Model 160 OCEAN ALERT MINI

™

12-Volt

air

inlet

tubes

1 2 3 4

Summary of Contents

Page 1 - Model 160 OCEAN ALERT MINI

Your purchase of a Wolo OCEAN ALERT™ Air Horn will complement your boat while offering an extra level of protection. Wolo’s products are manufactured

Page 2

COMPRESSOR INSTALLATION: Fig. 2 & 35. Install the compressor in a dry interior location. IMPORTANT: The compressor should not be mounted further

Page 3

WIRING: USING BOATS FACTORY HORN SYSTEM (TWO WIRE SYSTEM) Fig. 5WARNING: You are required to use the relay supplied with this horn kit to protect the

Page 4 - WARRANTY

ANY EXPRESSED WARRANTY NOT PROVIDED HEREIN IS EXCLUDED AND DISCLAIMED. THE IMPLIED WARRANTIES OF MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR PURPO

Wolo 160 Ocean Alert User Manual

Browse online or download User Manual for Equipment Wolo 160 Ocean Alert. Wolo 160 Ocean Alert User Manual

Summary of Contents

More documents for Equipment Wolo 160 Ocean Alert

Comments to this Manuals

Wolo 160 Ocean Alert User Manual

Browse online or download User Manual for Equipment Wolo 160 Ocean Alert. Wolo 160 Ocean Alert User Manual

Summary of Contents

More documents for Equipment Wolo 160 Ocean Alert

Comments to this Manuals

Related products and manuals for Equipment Wolo 160 Ocean Alert