Wolo 345 Animal House User Manual download pdf

Model 345 ANIMAL HOUSE™

INSTALLATION INSTRUCTIONS

INSTALLATION AND OPERATING INSTRUCTIONS

Your purchase of a WOLO horn is a perfect choice to compliment your vehicle. Our horns are manufactured with the finest of

materials. Each horn is bench tested before it is packaged to assure workmanship and quality, so you will have many years of

reliable service.

IMPORTANT: THIS HORN SHOULD NEVER BE USED AS A REPLACEMENT FOR VEHICLE ORIGINAL EQUIPMENT

HORN. ADDITIONALLY IT IS NOT TO BE USED AS A WARNING DEVICE, MODEL 345 ANIMAL HOUSE IS FOR OFF THE

ROAD AND SHOW USE.

MOUNTING CONTROL BOX

1. Select a mounting location that allows easy access to the knobs and controls on the

face of the animal house control box.

2. Mount the angle brackets (supplied) to each side of the ANIMAL HOUSE control box.

See fig. (A).

3. Place the ANIMAL HOUSE control box in the selected mounting location. Using the

mounting brackets as a template mark

location for mounting holes to be

drilled.

4. Drill holes (2) on marked locations

using a 1/8 drill bit and mount control

box with self tapping screws provided.

See fig. (B).

MOUNTING SPEAKER

5. Select a convenient location in the engine compartment that is dry and safe from the engines exhaust manifold heat.

Always face the speaker in a downward position. This will help prevent water from entering into the speaker. Using the speak-

ers mounting bracket as a template, mark hole locations (3) and drill using a 1/8 inch drill bit. Secure speaker with self tapping

screws provided (3). Make sure that the speakers opening is not blocked by any compartments which could reduce its loud-

ness.

WIRING (Fig. C)

6. TWIN BLACK is connected to the speaker in the engine compartment. Route wires through fire wall to speaker. Connect

either wire to one of the speaker wires. Then connect remaining wire to other speaker wire.

7. RED WIRE is connected to the fuse-block or a under dash wire that has power (+) 12 volts when the ignition is on. A 3 amp

inline fuse must be used (included in kit).

8. SINGLE BLACK WIRE is grounded. Secure wire under a bolt in the dashboard area, make sure that the METAL surface

around the bolt is clean of rust and paint to make a good electrical connection.

TESTING AND OPERATION

9. Put the vehicles ignition on so to power your ANIMAL HOUSE HORN during testing.

10. Turn the ANIMAL HOUSE VOLUME knob to the right. The red LED power indicator will light to show that the horn is now

ON.

Fig. A

Fig. B

Fig. C

Red Wire +12-Volt

Black wire connect to ground

Fuse 3-amps

Twin black wire

1 2

Summary of Contents

Page 1 - INSTALLATION INSTRUCTIONS

Model 345 ANIMAL HOUSE™INSTALLATION INSTRUCTIONSINSTALLATION AND OPERATING INSTRUCTIONSYour purchase of a WOLO horn is a perfect choice to compliment

Page 2

A. ANIMAL & MUSICAL: Place the slide switch to the top position. ANIMAL. Using the center knob marked ANIMAL, youcan select (9) different animal s

Wolo 345 Animal House User Manual

Browse online or download User Manual for Equipment Wolo 345 Animal House. Wolo 345 Animal House User Manual

Summary of Contents

More documents for Equipment Wolo 345 Animal House

Comments to this Manuals

Wolo 345 Animal House User Manual

Browse online or download User Manual for Equipment Wolo 345 Animal House. Wolo 345 Animal House User Manual

Summary of Contents

More documents for Equipment Wolo 345 Animal House

Comments to this Manuals

Related products and manuals for Equipment Wolo 345 Animal House