Wolo 815 Challenger User Manual download pdf

Your purchase of a Wolo’s Challenger Horn System is a perfect choice to

compliment your vehicle. Wolo’s products are manufactured with the finest

materials. Each horn is tested to insure it meets all manufacturing specification,

before it is packaged. If you need help installing your new Wolo horn, our

technicians are available to answer your questions, Monday through Friday from

9 AM to 4 PM EST by calling 1-888-550-HORN (4676).

HORN INSTALLATION (Fig. A)

1. Locate the desired area you wish to

mount the dual trumpet air horn. For best

results, the front of the horn should be

unobstructed so that the sound can carry

straight ahead.

2. Use the horn’s rubber gasket as a

template, mark hole locations and drill to

sizes as shown in Fig. A.

3. Secure the horn with the hardware

provided. Tighten screws evenly to

provide a good watertight seal..

4. Secure the flexible inlet hose into the

base of the horn base. Do not remove

the Teflon tape on the threaded end of the hose. The tape is used to help

prevent air leaks.

CAUTION: Avoid making any kinks or sharp bends in

flexible hose that will reduce airflow and alter the horn’s sound.

COMPRESSOR INSTALLATION (Fig. B)

5. Locate an area in the engine compartment

that is dry and safe from the heat of the

exhaust manifold heat. Try to mount

compressor as far to the front of vehicle as

possible to provide a good airflow around

compressor.

IMPORTANT! Do not mount on fender well

or other flexible material.

6. Using the compressors mounting brackets

as a template, mark the hole locations and

drill to size. 15/64’’. Secure the compressor

to the mounting surface with the hardware

provided.

INSTALLATION INSTRUCTIONS

For Model 815

CHALLENGER LV

1 2 3 4

Summary of Contents

Page 1 - CHALLENGER LV

Your purchase of a Wolo’s Challenger Horn System is a perfect choice tocompliment your vehicle. Wolo’s products are manufactured with the finestmate

Page 2 - TANK INSTALLATION (Fig. C)

TANK INSTALLATION (Fig. C)7. Locate a convenient area in the vehicle tomount the air storage tank. IMPORTANT!When selecting a mounting location for th

Page 3

WIRING COMPRESSOR (Fig . F)15. The compressor’s red wire is connected to (+) 12-volt power source usingthe fuse provided. IMPORTANT! The red wire must

Page 4 - WARRANTY