Your purchase of a Wolo warning light is the perfect choice to compliment your vehicle. Our warning lights are
manufactured with the finest of materials and each light is tested before it is packaged. Quality workmanship
and components are Wolo’s assurance of a product that will provide years of dependable service.
Before installation of this warning light is attempted, it is important to read these instructions completely. The
lives of people are dependent on proper installation. The person installing this light must have advanced
knowledge of the proper method of installing warning lights to a vehicle, as well as, knowledge of the
vehicle's electrical system. Again, read this manual completely and note any messages marked
‘‘IMPORTANT” or ‘‘WARNING”. A safe installation will prevent serious injury and/or damage to the vehicle.
IMPORTANT: Installation of this warning light may require drilling to the vehicle. The installer must carefully
inspect both sides of any location that will be drilled to ensure that there are no components, wires and/or any
vehicle parts that could be damaged when drilling.
IMPORTANT: Always de-burr any drilled holes to ensure that there are no sharp edges. Install the plastic
grommet into the hole that the wires are being routed through. Always refer to the vehicle’s shop manual for
the deployment location of the air bags. Never install the on/off switch, wires and/or components in the
deployment area of any air bag. Improper installation could reduce the effectiveness of the vehicle's air bag
system and/or project an object that could cause serious personal injury or death to the driver or passenger.
The user/installer assumes all responsibility to properly access a safe mounting location for the switch to
provide ultimate safety to the driver and passengers inside the vehicle.
WARNING: This warning light contains GEN 3 high intensity LEDs. To prevent permanent eye damage, DO
NOT stare into the light beam at close range.
MOUNTING WITH SCREWS (FIG. A & B)
1. Select the location you wish to mount the warning light. For
best results, the installer should make sure the lens is
unobstructed so that the light can be seen at 360 degrees.
2. Using the holes in the warning light’s base, mark the three (3)
hole locations for mounting the light. Lift the light from the
mounting location and drill holes using a 3/16” drill bit.
NOTE: There are two methods to route the warning lights
wires:
2A. Route the wires through the notch in the base of the light.
2B. Route the wires through a hole directly under the base of
the warning light.
3. If needed, drill a hole for the wires using a 5/16” drill bit. De-
burr the drilled hole and insert the provided plastic grommet
into the hole. The plastic grommet will ensure that there are no
sharp edges that could damage the wires. IMPORTANT: If
waterproofing is required, use silicone sealant around wires
and plastic grommet.
4. Secure the base of the warning light to the vehicle using only
the hardware provided. To prevent vibration and water leaks
always use the rubber gasket provided.
INSTALLATION INSTRUCTIONS FOR APOLLO 8
GEN 3 LED WARNING LIGHT 8 SELECTABLE LIGHT
PATTERNS MODEL 3080PPM-A, 3085PPM-B, 3090PPM-R,
3095PPM-C
& 3097PPM-G
FIG. B
FIG. A
(2 pages)
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals